Luma 25 V2

Both propeller guards use a symmetrical design, so the two guards can be assembled interchangeably.

Each guard is made from 1x Main part (A), 2x Base parts (B) and 6x Strut parts (C).

Each Base part has four motor mounting holes. One hole is directly in line with one of the three protruding sections of the base. These protruding sections must face toward the middle of the guard.

Build the Base parts with the three protruding sections facing upwards.

Press the six strut pieces into their locations by hand, seating them most of the way before using needle nose pliers to firmly cinch them into their slots.

If additional strength is required, an adhesive such as E6000 can be used to secure the printed parts together.

The rear antenna assembly consists of 1x TPU part (A), 1x XT-30 Connector (B) and 1x XT-30 Mounting Board (C).

Insert the mounting board into the TPU assembly from either side. Position the XT-30 connector in the TPU assembly and align it with the mounting board. The connector and mounting board will be secured together during the soldering stage of your build.

Fit the 4 × M2 20 mm aluminium standoffs to the Bottom plate with 4 × M2 8 mm bolts.

Fit the 4 × M2 16 mm hex stack bolts and secure with 4 × M2 plastic nuts.

Choose the VTX riser that matches your VTX. Install it at the rear stack position using 4 × M2 10 mm hex bolts.

Install the Front FPV Camera Mounts and Rear Antenna Mount over the corresponding standoffs.

Install the assembled propeller guards onto the aluminium standoffs.

Ensure each guard is correctly seated and aligned with the frame before continuing.

Secure the front HD Camera Mount to the Top plate using 4x M2 8mm Hex Bolts, 4x M2 Steel Washers and 4x M2 Steel Nuts.

Install the supplied M5 hardware into the mounting holes of the HD Camera Mount.

Secure the Top plate to the standoffs using 4x M2 8mm Hex Bolts.

Line the Battery Pad up with the Top plate. Lightly lay it on the plate in the correct position before pressing down firmly to secure it in place.