Luma 5 Pro

Hardware is broken down into the following packaging.

Insert the 8 × M3 steel press nuts into the four arms and four Mid Plate locations. Use the correct installation method shown in the video.

Position the Bottom Plate with the triangle oriented towards the front of the frame.

Position the four arms on top of the Bottom Plate. The two shorter arms are installed at the front, while the two longer arms are installed at the rear.

Ensure all press nuts are oriented upwards.

Install 4 × M3 × 8 mm cap-head hex bolts through the Bottom Plate and into the corresponding press nuts.

Fit the Keystone between the arms as illustrated.

Install the flight-stack hardware from the underside of the Mid Plate.

Choose the hardware for your stack:

• M3 × 22 mm countersunk bolts and M3 Nylon Nuts
• or M2 × 18 mm countersunk bolts with M2 Nylon Nuts

Install the selected bolts through the desired stack-mounting locations in the underside of the Mid Plate.

Secure the bolts from the top using the matching nylon nuts.

Install the Mid Plate onto the arms.

Secure the Mid Plate using 4 × M3 × 12 mm cap-head hex bolts, inserted through the Bottom Plate and arms into the press nuts.

Carefully trim away the protruding side tabs from the XT60EW-M connector using a sharp hobby knife or side cutters.

Compare the connector with the original and modified examples shown below.

Install the modified connector into the rear antenna mount.

Secure it using 2 × M2.5 × 8 mm countersunk hex bolts, inserted through the mount.

Install 2 × M2 × 25 mm Standoffs into the front bumper and FPV camera mount.

Place the mount between the two camera plates and secure it using 4 × M2 × 8 mm cap-head hex bolts.

Install the rear antenna mount over the two rear Standoffs.

Align the Battery Pad with the Top Plate and lightly position it in place before pressing down firmly to secure it.

Install the Top Plate onto the M2 × 20 mm Standoffs and camera plate tabs.

Install 4 × M2 × 8 mm countersunk hex bolts through the rear four holes of the Top Plate and into the M2 Standoffs.

Install 2 × M2 × 8 mm cap-head hex bolts through the front two holes of the Top Plate and into the M2 Standoffs.

Insert 2 × M2 × 25 mm Standoffs into the front HD camera mount.

Install the M5 flat Phillips-head steel bolt and M5 hex flange nut into the HD camera mount.

Install the HD camera mount between the FPV camera plates.

Secure the mount using 4 × M2 × 8 mm cap-head hex bolts.

Install the four arm bumpers onto the ends of the arms.

Pick either the 20 × 20 mm or 25.5 × 25.5 mm rear VTX riser to match your VTX size.

Install the desired riser at the rear of the Mid Plate using 4 × M2 × 14 mm bolts.

Once the FC/ESC stack has been installed, the Stack Topper is used on top to hold the RX Receiver as pictured.

Secure the Stack Topper using 4 × M3 Nylon Nuts.